查詢結果分析
相關文獻
- 麥克風陣列排列模式在微銑削刀具磨耗偵測之影響分析
- Dialogism and Retreat in “The Sound and the Fury”
- 數位聲音廣播可行性分析與發展動態
- Marine Diesel Engine Noise Identification by Using Holography Reconstruction
- An Adaptively IIR Active Control of Sound in a Pipe
- 電腦聲音控制介面之研究
- 「教師聲音」在專業自主上之意義
- 多媒體光碟上的聲音--電腦音樂檔的數位處理與多媒體MIDI音樂
- 聲光信號對反應時間影響之研究
- 音域圖對臺灣嗓音異常者嗓音治療療效之臨床評估初步研究
頁籤選單縮合
題名 | 麥克風陣列排列模式在微銑削刀具磨耗偵測之影響分析=Analysis of Microphone Array Arrangement for Sound Based Micro Tool Wear Monitoring |
---|---|
作者姓名(中文) | 呂長恩; 盧銘詮; 鄭瑞霖; | 書刊名 | 應用聲學與振動學刊 |
卷期 | 6:2 2014.12[民103.12] |
頁次 | 頁31-44 |
分類號 | 446.893 |
關鍵詞 | 麥克風陣列; 刀具磨耗偵測; 微銑削; 聲音; Microphone array; Tool wear monitoring; Micro milling; Audible sound; |
語文 | 中文(Chinese) |
中文摘要 | 在切削加工過程中,應用聲音建構自動化刀具狀態偵測系統容易因背景噪音的干擾而造成系統之誤動作,因此為了提升偵測系統的穩定性,抑制噪音技術扮演著重要的角色。本研究探討環狀排列麥克風陣列在降低干擾噪音之效能,以及對於刀具磨耗偵測系統的影響。實驗過程採用直徑700μm之微細銑刀,工件為SK2高碳鋼,並在切削過程以喇叭提供人工噪音源,並利用麥克風陣列擷取切削時的聲音訊號。擷取之聲音訊號以整合麥克風陣列與偉納濾波器進行濾波處理,結果顯示麥克風陣列整合偉納濾波能有效的改善噪音對微刀具磨耗偵測之影響。另外,分析麥克風陣列排列方式對刀具磨耗辨識之性能影響方面,結果顯示整合環列麥克風陣列較直線排列麥克風陣列系統能更有效的去除雜訊,在適當選擇特徵值之頻寬厚,在高能量之噪音干擾下,可以達到100%的辨識成功率。 |
英文摘要 | The effect of the arrangement of microphone array on micro tool wear monitoring in micro milling was studied in this paper with two arrangements for the installation of microphone arrays. In experimental setup, 700 μm micro end mill was used in cutting SK2 workpiece. To simulate the noise occurring during factory, the speaker was installed inside the cutting chamber to generate the broad band noise during cutting. After sound signals were collected by microphone during cutting with various tool wear conditions, they were processed by system with the combination of the microphone array filter and Wiener filter. The results show that the classification rate can be improved by adopting the microphone array along with Wiener filter compared to the case without filters selected. By the way, circular arrangement of microphone can provide the better classification rate than the case with microphone array installed in linear arrangement. With proper selection of bandwidth for feature selection, 100% classification rate can be obtained by processing the sound signal with the combination of microphone array and the Wiener filter. |
本系統之摘要資訊系依該期刊論文摘要之資訊為主。