查詢結果分析
來源資料
相關文獻
- Simulation of the Injection-Compression Molding Process Using CV/FEM Technique
- 旋窯爐之三維熱流場數值模擬
- 軟弱黏土層的壓密行為之研究
- 箱籠護岸結構之力學特性與數值模擬
- 應用平行運算於二維潰壩之模擬
- 有限元素法應用於銲接數值模擬分析
- 以數值模擬預測樓版表面材衝擊音衰減特性之研究
- Modified Finite Element Solutions for Planar Entry Flow of an Oldroyd-B Fluid
- Torsional Vibration Analysis of a Damped Shaft System
- 汽機葉片之機械力學分析研究
頁籤選單縮合
題 名 | Simulation of the Injection-Compression Molding Process Using CV/FEM Technique=利用控制體積/有限元素技術模擬射出壓縮成型之製程 |
---|---|
作 者 | 陳永徵; 陳夏宗; 章明; 何淳雪; | 書刊名 | 中原學報 |
卷 期 | 24:1 1996.01[民85.01] |
頁 次 | 頁37-45 |
分類號 | 472.22 |
關鍵詞 | 射出壓縮成型; 控制體積; 有限元素法; 壓縮速度; 數值模擬; Injection-compression molding; Control volume; Finite element method; Simulation; Compression speed; |
語 文 | 英文(English) |
中文摘要 | 本研究條基於Hele剖law流動模式配合控制體積 有限元素方法來模擬射出壓縮成型之製程,並預 測*容膠波前的運動以及成型壓力、溫度及流遠的分 佈o研究中發現壓縮的速度是影響成型壓力最重要 的因素,在適當的壓縮連度下,成型壓力比傳統射 出成型為低,因而殘留應力可以隨之降低。同時研 究也發現利用射出壓縮成型成品在充填完成之後的 溫度分佈也較為均勻。若射出轉移或壓出成型的時 間太短,成型壓力也相對變高。 |
英文摘要 | In the present study, a numerical alogrithm is developed in order to simulate the non-isother mal filling and compression stages of the injection-compression molding process. The generialized Hele-Shaw flow model combined with the control volume/finite element method is implemented to predict the melt front advancement and the distributions of pressure, temperature and flow velocity dynamically during the molding process. From on the simulated results, it was found that the compression speed is the most important factor that affect the molding pressure. Under proper compression speed, the predicted molding pressure is lower than that required by the purely conventional injection molding and the part residual stress can be minimized. Itwas also found that part temperature is more uniform at the end of filling process by using injection-compression molding. Ifthe switch time from injection to compression is too low, it may also cause high moldmg pressure. |
本系統中英文摘要資訊取自各篇刊載內容。