查詢結果分析
來源資料
相關文獻
- 虛擬模態振形法應用於多接點子結構之建模
- 應用虛擬模態振形法於模擬複雜性子結構時之精確度極限
- 應用數值最佳化理論提升虛擬模態振型法於鑑別轉子系統基座頻率響應函數之精度
- 以虛擬模態振型法鑑別具阻尼效應之轉子基座的動態特性
- 虛擬模態振形法應用於葉片輪結構之建模研究
- 虛擬模態振形法應用於懸臂結構之建模研究
- 解讀生物巨分子結構資料庫PDB與SCOP
- A Partial Exhaustive Search for Good Multiple Recursive Generators of Order Two
- First Principles Calculations of Structural and Defect Properties of High-Temperature Intermetallics
- 利用定量會聚束電子繞射方法研究材料的電子結構
頁籤選單縮合
題 名 | 虛擬模態振形法應用於多接點子結構之建模=Modeling of Substructures with Multiple Joints by Pseudo Mode Shape Method |
---|---|
作 者 | 楊大中; 蔡盈安; 蒯光陸; | 書刊名 | 技術學刊 |
卷 期 | 26:3 2011.09[民100.09] |
頁 次 | 頁179-186 |
分類號 | 446.8 |
關鍵詞 | 子結構; 剛體模態; 多接點; 頻率響應函數; Substructure; Rigid body mode; Multiple joint; Frequency response functions; |
語 文 | 中文(Chinese) |
中文摘要 | 虛擬模態振形法 (Pseudo Mode Shape Method, PMSM) 僅需在子結構與母結構接點處施力,量測其頻率響應函數 (FRF)。透過 FRF可得到子結構的模態參數及接點處的虛擬模態矩陣,以此反推出子結構之等效質量、阻尼和勁度矩陣。由於僅需量測接點處的 FRF,因此實驗過程可簡化許多。可有效解決大型複雜結構,無法進行完整模態測試的缺點。本文延伸作者過去發表的虛擬模態振形法,推導子結構之剛體模態和多接點子結構之應用。本文以一樑結構實驗驗證,實驗頻寬為 4000 Hz。PMSM對子結構建模,與實驗結果比較,自然頻率幾乎沒有誤差。將 PMSM所建立子結構矩陣與有限元素法 (Finite Element Method, FEM) 所建立之母結構矩陣在接點處結合,與實驗 FRF比較。比較結果良好,自然頻率最大誤差為第 11個模態,誤差為 6.724%。 |
英文摘要 | The Pseudo Mode Shape Method (PMSM) requires only the measurements of the Frequency Response Functions (FRFs) at the joints between the substructures and the mother structure. The modal parameters and a pseudo modal matrix of the substructure can then be derived from the FRFs, and the equivalent mass, damping and stiffness matrices of the substructure may be subsequently obtained. The experimental procedures are considerably simplified because only the FRFs at the joints are required, which solves the problems of incomplete modal shapes in measurement for large complicated structures. This paper extends the authors’ previous work on the PMSM to include rigid body modes and to substructures involving multiple joints with the mother structure. Experiments with a beam structure were conducted to evaluate the accuracy of the proposed method. The frequency range was set to 4000 Hz. A comparison of the natural frequen- cies of the modeled substructure obtained by the PMSM versus experimental results shows good agreement. After joining the PMSM matrices of the substructure with the Finite Element Method (FEM) matrices of the mother structure, the FRFs of the integrated system compare well with experimental results. The largest error of natural frequency is 6.724% for the 11th mode. |
本系統中英文摘要資訊取自各篇刊載內容。