查詢結果分析
來源資料
相關文獻
- 金屬射出成形用水溶性黏結劑之研究
- PEG分子量對射料流體性質的影響
- 有機藥劑前處理對透明塗裝木材光變色之抑制效應
- 臺灣雲杉(Picea morrisonicola Hay.)體胚發生與植株再生
- 聚嗍碸/聚乙二醇複合膜分離二氧化碳與甲烷混合氣體之研究
- 多陰離子性界面活性劑之研究(1)--合成及基本界面性質
- 雙性聚乙二醇接枝高分子的合成與性質
- Influence of Polymer Blending on Poly (ε-Caprolactone) Degradation
- Kinetics of Ozonation of Polyethylene Clycol In Printed Wiring Board Electroplating Solution
- 雙性聚乙二醇接枝高分子的合成與性質
頁籤選單縮合
題名 | Influence of Polymer Blending on Poly (ε-Caprolactone) Degradation |
---|---|
作者 | Lin, Wen-jen; Flanagan, Douglas R.; Linhardt, Robert J.; | 書刊名 | 醫學工程 |
卷期 | 12:6 民89.12 |
頁次 | 頁255-259 |
分類號 | 410.1644 |
關鍵詞 | 聚乙二醇; Poly(ε-caprolactone); Polyethylene glycol; Blends; |
語文 | 英文(English) |
英文摘要 | This study was designed to enhance the degradation rate of poly (ε-caprolactone) (PCL) via blending with less crystalline low molecular weight PCLs (MW 300, 530 and 900) or hydrophilic polyethylene glycols (MW 600 and MW 3,350). The thermal properties and crystallinities of blends were measured by differential scanning calorimetry. The acid-catalyzed hydrolysis of the blends was conducted in aqueous p-toluenesulfonic acid by measuring weight loss. Incorporation of PCLL into PCL reduced the crystallinity of the polymers to 45-58%, which depended on the weight ratio of PCLL in blends. All blends showed two degradation phases, a rapid initial weight loss during the first 5 days indicating the loss of PCLL followed by a slow decline in weight corresponding to the loss of PFL. The slope of the second phase was approximately the same as that observed for pure PCL. These results indicated that PCL and PCLL degraded separately in the blends. The incorporation of PEG 600 into PCL only slightly reduced polymer crytallinity. However, PCL and PEG 3,350 were separately crystallized in the blends. The biphasic weight loss behavior was also present in PCL-PEG blends, where the Peg domain in blends leached out rapidly during the first few days resulting in micropores in the matrix. |
本系統之摘要資訊系依該期刊論文摘要之資訊為主。