查詢結果分析
來源資料
頁籤選單縮合
題 名 | 廢塑膠再生處理: 離心式抽絲法之可行性研究=Reproducing of Waste Plastics: The Feasible Study of Centrifugal Method |
---|---|
作 者 | 楊正雄; 李貴琪; | 書刊名 | 華岡紡織期刊 |
卷 期 | 5:3 1998.09[民87.09] |
頁 次 | 頁250-256 |
分類號 | 478.11 |
關鍵詞 | 聚丙烯; 廢塑膠; 離心式抽絲法; 再生處理; Polypropylene; Waste plastics; Centrifugal spinning; Reproducing; |
語 文 | 中文(Chinese) |
中文摘要 | 本文係以回收之聚丙烯為原料,伺服馬達及加熱器為實驗器材,利用馬達旋轉所 產生之離心力將熔融聚丙烯甩出成絲。在研究中針對馬達轉速及溫度之改變對抽絲效果來進 行探討,並且採聚酯纖維為強化材,聚丙烯絨維為基材,依強化材和基材之重童百分比60:40 之比例,成形時間4min,成形壓力40kgf/cm�插A成形溫度200℃之條件下製成廢纖板。 |
英文摘要 | We use D.C motor, heater and recovered polypropylene as equipment and material. Silk was formed by fused P. P and forced by the centrifugal of the running motor. In this study, we concerned about the influence on the silk under different motor speed and temperature. Both using polyester fiber and polypropylene fiber as reinforced and matrix material. Then we mixed them into 60:40 according to the weight. Other treating conditions was based on 4 minutes, 40kgf/cm�� and 200℃. |
本系統中英文摘要資訊取自各篇刊載內容。