查詢結果分析
來源資料
相關文獻
- 廢熱回收熱電轉換系統中的多孔性集熱器之熱傳特性實驗研究
- 往復運動對內設凸起物管流熱傳現象影響之實驗研究
- Numerical Modeling of Transient Natural Convection Heat Transfer from a Tank-In-Pool Type Reactor
- T-型模具之有限元素法PID溫度控制分析
- Computer Simulation of Electro-Thermomechanical Interactions of an Oxygen Sensor during Warm-Up
- 植物組培瓶內熱傳模式之研究
- 鋁合金消失模鑄造法界面熱傳係數之量測與其在凝固模擬上之應用
- A Study on Filmwise Condensation on Horizontal Surfaces--Flat Plate with Uniform Heat Flux
- 冷媒R-134a對池核沸騰的熱傳增強方法
- 鰭片式熱交換器之熱傳分析基礎
頁籤選單縮合
題名 | 廢熱回收熱電轉換系統中的多孔性集熱器之熱傳特性實驗研究=Experimental Study of Heat Transfer Characteristics in the Porous Heat Absorber of Thermoelectric Generator System for Waste Heat Recovery |
---|---|
作者姓名(中文) | 曾憲中; 鄭澤明; 李峰; 陳易辰; | 書刊名 | 建國科大理工期刊 |
卷期 | 33:2 2014.04[民103.04] |
頁次 | 頁1-15 |
分類號 | 440.35 |
關鍵詞 | 多孔性材料; 熱傳; 堆疊通道; 黃銅粒; Heat transfer; Porous materials; Packed channel; Brass beads; |
語文 | 中文(Chinese) |
中文摘要 | 本研究旨在開發一種用於車輛引擎廢熱回收熱電轉換系統中的多孔性集熱器,以高效的集熱能力提升廢熱回收熱電轉換系統的發電性能,將以實驗方法觀察充滿黃銅粒堆疊物之矩形通道在不對稱受熱下之熱傳特性,採用空氣為冷卻流體,多孔性材料係使用黃銅珠密實堆疊而成,黃銅珠粒徑(d)尺寸有2 mm、4 mm與6 mm等三種,測試通道寬度(W)固定為60 mm,變動參數為相對堆疊通道長度(L/d=5~60)、相對堆疊通道高度(H/d=1.67~15)與雷諾數(Re_D=755~7921、Re_(dp)=38~2703)等。實驗結果指出,與通道水力直徑(D_h)相比較,黃銅珠粒徑(d)可能更適合作為整合堆疊通道熱傳數據的尺度參數;此外,粒子紐塞數(Nu_(dp))會隨著相對通道長度(L/d)減少而增加,但相對通道高度(H/d)對(Nu_(dp))的影響則不敏感;最後,本研究歸納所有實驗數據提出不同相對通道長度(L/d)、相對通道高度(H/d)與粒子雷諾數(Re_(dp))下均適用之平均與局部粒子紐塞數(Nu_(dp)與Nu_(dp,x))之經驗修正式。 |
英文摘要 | This study will develop a porous heat absorber used in the thermoelectric generator for the vehicle engine waste heat recovery. The high performance of the porous heat absorber may enhance the generating electricity of the thermoelectric generator. Hence, the heat transfer characteristics in the asymmetrically heated rectangular channels fully filled with porous materials will be investigated experimentally. Air was used as the coolant. The porous materials were packed by brass beads with average diameters (d) of 2, 4 and 6 mm. The channel width (W) was fixed to be 60 mm. Variable parameters were the relative length of packed channel (L/d=5~60), the relative height of packed channel (H/d=1.67~15) and the Reynolds number (Re_D=755~7921 and Re_(dp)=38~2703). The results indicated that the bead diameter (d), rather than the hydraulic diameter (D_h), may be a proper parameter to generalize the data for heat transfer in a packed channel. Besides, the particle Nusselt number (Nu_(dp)) increased with decreasing L/d, while the H/d was not sensitive to Nu_(dp) . Finally, the correlations of average and local particle Nusselt numbers (Nu_(dp) and Nu_(dp,x)) for various L/d, H/d and Re_(dp) were provided. |
本系統之摘要資訊系依該期刊論文摘要之資訊為主。