頁籤選單縮合
題 名 | 板金滾輪矯直機入/出口干涉量之快速設定法=A Rapid Method of Setting Inlet/Outlet Interferences for Sheet Metal Roll Straighteners |
---|---|
作 者 | 羅斯維; 李孟憲; | 書刊名 | 技術學刊 |
卷 期 | 27:2 2012.06[民101.06] |
頁 次 | 頁65-71 |
分類號 | 472.23 |
關鍵詞 | 滾輪矯直; 滾輪干涉量; 板金成形; Roll straightening; Roll interference; Sheet metal forming; |
語 文 | 中文(Chinese) |
中文摘要 | 滾輪矯直機的滾輪位置變化會影響板材的矯直程度,因此調整入/出口端的滾輪干涉量是板材矯直的關鍵。本研究提出的干涉量設定流程,將實驗數據導入二次函數,計算出入/出口干涉量。相較於傳統以經驗方式、試誤法或者數值分析預測干涉量,此方法能有效率地調整到適當的干涉量,以簡單的式子避開繁瑣的理論公式,相信更能被業界所接受。運用於不同板材與規格的矯直實驗後發現: SPCC板厚 1 mm與 Al-5052板厚 2 mm在矯直後,板材平坦度的確有達到規範標準,但在 Al-5052板厚 0.5 mm的矯直實驗,板材平坦度卻無法達到規範標準。由文獻資料得知,矯直機所能矯直的板材規格受到滾距、滾徑、滾輪數等參數的影響,本文並依此推導出機台矯直能力的上下限理論值,理論顯示 0.5 mm之板材厚度已接近實驗機台工作範圍的極限。 |
英文摘要 | The roller position of a straightening machine affects the final straightness of sheet metal. Adjusting the interferences between rollers at the entrance as well as the exit is vital to the straightening process. Contrary to the conventional trial-and-error method, a rapid procedure using the second order function to fit the experimental data is developed to determine the inlet/exit roller interferences. This novel method is efficient and sufficiently accurate, without a complicated theorem and calculation. It has been proven successful for the 1 mm thick SPCC steel and the 2 mm thick A5052 aluminum sheets. However, the result of the experiment using the 0.5 mm aluminum sheet does not fulfill the requirement after straightening. Therefore in this paper, the theoretical limitations of the sheet thickness have also been derived based on both the geometric parameters and the material properties. From the theorem, we already showed that the 0.5 mm workpiece is close to the limitation of the capability of the present rig. |
本系統中英文摘要資訊取自各篇刊載內容。