查詢結果分析
來源資料
相關文獻
- 利用電解-芬頓程序處理含苯胺之廢水
- 陰離子對Fenton程序去除苯胺之影響
- Upgrading of Textile Wastewater Treatment Plant by Operation Control and Fenton Process
- 利用電-芬頓程序處理酚醛樹脂廢水
- 利用電-芬頓程序處理含有機酸之廢水
- 銅及鎘離子對亞鐵離子催化過氧氫分解氯酚類污染物之效應
- 使用H[feaf]O[feaf]/UV程序去除垃圾滲出水中色度與有機物之可行性研究
- UV/H[feaf]O[feaf]系統分解水中二氯苯污染物之研究
- 鈰含量與過氧化氫濃度對CeO₂/HA觸媒催化苯胺之濕式過氧化反應之影響
- FeSO₄催化雙氧水製氧氣之研究
頁籤選單縮合
題 名 | 利用電解-芬頓程序處理含苯胺之廢水=Treatment of Wastewater Containing Aniline by Electro-Fenton Process |
---|---|
作 者 | 盧明俊; 黃耀輝; 鍾雅文; 徐敬妮; | 書刊名 | 嘉南學報 |
卷 期 | 28 2002.11[民91.11] |
頁 次 | 頁73-84 |
分類號 | 445.462 |
關鍵詞 | 電解Fenton法; 苯胺; 亞鐵離子; 過氧化氫; 高級氧化程序; Electro-Fenton; Aniline; Ferrous ions; Hydrogen peroxide; Advanced oxidation process; |
語 文 | 中文(Chinese) |
中文摘要 | 電解-芬頓(electro-Fenton)為一種新的高濃度有機廢水的電化學處理程序,主要原理是利用電解反應使鐵離子於陰極被電解還原成亞鐵離子,並立即與過氧化氫反應,來氧化廢水中的有機物,進而達到去除污染物的效果。本研究是以電解-芬頓程序與傳統芬頓程序做比較,觀察此兩種程序對於廢水中含有苯胺之處理效果。另外,探討不同濃度之亞鐵離子及過氧化氫之添加方式對於污染物之處理,尋求最佳的處理效果。 結果發現電解-芬頓程序較傳統芬頓有更佳的處理效果,對於0.01M苯胺而言,其COD去除率接近90%。此外7.7g/l之過氧化氫的添加方式,以四次添加的效果較一次添加的效果為最佳。而當亞鐵離子分別為0.5g/l、1.0g/l、1.5g/l時,則發現1.0g/l,過氧化氫採以分四次添加方式,於pH調整於2.0,通入2.0安培之電流時的條件下,對於廢水中含0.01M之苯胺有最佳的處理效果,約可達99%之去除率。 |
英文摘要 | Aniline is a resistant organic compound, and only about 80% of theoretical COD can be detected. Therefore, the COD value of aniline solution treated by only Fenton’s reagent increased with time of reaction because more degradable intermediates were generated from the aniline oxidation. When the experimental conditions were controlled as a follows, [aniline]=0.01 M, □=1 g/l, □□=7.7g/l and initial pH=2.0, the COD value of the reaction solution increased 20% after 2 hours of Fenton treatment. However, when 2.0 A of electric current was introduced in the system, namely electro-Fenton process, 90% of COD can be reduced. The dosage of ferrous lons affected the oxidation of aniline solution, and the optimum occurred at 1.0g/l. The treatment efficiency for the system of four-step addition with hydrogen peroxide was higher than that for the one-step. |
本系統中英文摘要資訊取自各篇刊載內容。