查詢結果分析
來源資料
頁籤選單縮合
題名 | 渦輪機入口燃氣溫度的計算=Calculation of Turbine Inlet Temperature |
---|---|
作者 | 林榮山; Lin, Jung-shan; |
期刊 | 台電工程月刊 |
出版日期 | 19990800 |
卷期 | 612 1999.08[民88.08] |
頁次 | 頁36-42 |
分類號 | 448.14 |
語文 | chi |
關鍵詞 | 出口修正溫度; 焓值; 能量平衡; 氣體特性表; 絕對焓; 設定焓; Outlet temperature corrected; OTC; Enthalpy; Energy balance; Gas property table; Absolute enthalpy; Arbitrary enthalpy; |
中文摘要 | 接收試驗時,渦輪機的入口溫度一般都是以計算的方式間接得到 的,在計算上先得到渦輪機入口燃氣的焓值,然後以氣體特性表求出 燃氣溫度。 本文以Siemens V84.2氣渦輸機為例,說明如何利用氣渦輸機的能 量平衡關係推演求出空壓機的入口空氣流量與渦輪機的入口燃氣焓值 公式,公式中的一些常數都是興達複循環Siemens V84.2氣渦輸機的特 性值。有了燃氣焓值,而且經化驗求得燃氣組成之後,我們藉著氣體 特性表即可求出渦輪機的入口溫度。 為了驗證計算方式的正確,本文最後以興達複循環氣渦輪機GT21 單循環接收試驗時的數據為例計算渦輪機入口燃氣溫度,並與Siemens 當時以TOGATHER程式所計算的溫度作比較。 |
英文摘要 | The inlet temperature of turbine is always obtained through calculation during acceptance test. First, the enthalpy of turbine inlet gas is calculated, and then, with the enthalpy and flue gas constituents, the inlet gas temperature can be acquired from Gas Property Table. By using energy balance relations of gas turbine, this paper shows how to deduce formulas for the air mass flow at compressor inlet and the flue gas enthalpy at turbine inlet. In order to prove correctness of these formulas the data measured during acceptance test of Hsin-Ta GT21 is taken to calculate turbine inlet temperature. It showed that the result quite similar to these of Siemens TOGATHER program in acceptance test. |
本系統之摘要資訊系依該期刊論文摘要之資訊為主。