查詢結果分析
相關文獻
- A Simple Model for Estimating Surface Porosity of Cake in Cake Filtration of Submicron Particles
- Ternary Consolidation Stage in Consolidation Dewatering of Sludges
- 中孔對活性碳在液相中吸附能力的影響
- 規則立方堆積可變形粒子床受單軸向壓縮變形之研究
- The Role of Elastic Effect in Filtration of Particles Suspended in Viscoelastic Polymeric Solution
- 纖維集合體應用於無土栽培之研究
- 紡織品塗佈材料之平行面與垂直面孔隙度
- 電場濾餅過濾機構之分析
- 試樣孔隙度對自行傳播燃燒反應之影響
- 百喜草植生覆蓋對坡地生態環境特性影響之探討
頁籤選單縮合
題名 | A Simple Model for Estimating Surface Porosity of Cake in Cake Filtration of Submicron Particles=估計次微米粒子在濾餅過濾中之濾餅表面孔隙度的簡單模式 |
---|---|
作者 | 黃國楨; 呂維明; | 書刊名 | Journal of the Chinese Institute of Chemical Engineers |
卷期 | 28:2 1997.03[民86.03] |
頁次 | 頁121-129 |
分類號 | 460.024 |
關鍵詞 | 次微米粒子; 濾餅; 孔隙度; Submicron particle; Cake filtration; Cake porosity; Colloid; Solid-liquid separation; |
語文 | 英文(English) |
中文摘要 | 本研究提出了一個以力平衡為基礎的簡單模型,藉以估計次微米粒子在濾餅過濾 中的濾餅表面孔隙度。並討論影響粒子堆積的主要因素,例如:濾速、粒徑、粒子的表面電 位、以及電解質濃度等。當流體拉曳力和粒子間之淨作用力相等時,濾餅會堆積得最緊密。 在小的濾速下,一定粒徑之次微米粒子在同一表面電位下,濾餅之孔隙度會隨著濾速之增加 而減小;但在大濾速的範圍下,孔隙度則會隨著濾速之增加而變大。在低表面電位下,粒子 的孔隙度會隨著粒徑的增大而增大,隨電解質濃度的增加而降低。然而,在表面電位高於臨 界值後,則趨勢會相反。本研究的結果和布朗動態模擬的數值非常接近,但只需要很短的計 算時間。 |
英文摘要 | Abstract - A force balance model for estimating the surface porosity of cake in cake filtrations of submicron particles is proposed. The major factors affecting particle packing, such as filtration rate, particle size, zeta potential of particles, and electrolyte concentration, are discussed. A most compact cake is constructed when the drag force is equal to the net interparticle force. For a given size of particles with a given surface potential, the value of surface porosity decreases in a small filtration rate region but increases with filtration rate in a large filtration rate region. For particles with a low zeta potential, the surface porosity increases with the increase of particle size and the decrease of electrolyte concentration. However, this tendency will be reversed if the particles have a zeta potential higher than the critical value. The results estimated by this study are very close to those obtained by the Brownian dynamic simulation, but minimal calculation times was required. simulation, but minimal calculation times was required. |
本系統之摘要資訊系依該期刊論文摘要之資訊為主。