查詢結果分析
來源資料
相關文獻
- 低壓射蠟快速模具研製與應用
- Neural Network Procedures for Taguchi's Dynamic Problems
- 放電加工多重品質設計
- 放電加工製程參數最適化之研究
- 品質工程之田口式實驗設計
- Manufacturing Process Optimization of Short Glass Fiber Reinforced Polycarbonate Composites in Injection Molding
- 以田口分析法探討實驗參數對碳六十產率之影響
- 以田口方法探討不同氯化鈉濃度切削液對JIS SUS 304不銹鋼鑽削時之刀具壽命研究
- 田口動態參數設計法於模糊控制上的應用
- 田口非線性動態品質特性在模糊控制上的應用
頁籤選單縮合
題名 | 低壓射蠟快速模具研製與應用=Fabrication and Application of Low-Pressure Wax Injection Rapid Toolings |
---|---|
作者 | 郭啟全; 蔡仁隆; 蔡仁隆; Kuo, Chil-chyuan; Chen, Bing-cheng; Chen, Bing-cheng; |
期刊 | 建國科大理工期刊 |
出版日期 | 20150400 |
卷期 | 34:2 2015.04[民104.04] |
頁次 | 頁105-119 |
分類號 | 446.8924 |
語文 | chi |
關鍵詞 | 矽膠模具; 低壓射蠟; 田口方法; Silicone rubber mold; Low-pressure wax injection molding; Taguchi method; |
中文摘要 | 本研究提出一個快速與低製造成本之射蠟模具製造技術,並運用田口方法探討低壓射蠟之較適製程參數。研究發現,影響低壓射蠟之蠟溢出量的最大影響因子為射蠟時間,其次是射蠟壓力。較適低壓射蠟製程參數為射蠟溫度82℃、射蠟時間2秒、射蠟壓力0.6 kgf/cm2以及矽膠模具預熱溫度60℃。 |
英文摘要 | This paper proposed a method for fabricating silicone rubber molds for low-pressure wax injection molding. The wax spilling is one of the most troublesome problems during wax injection molding process. From the point of view of green manufacturing, the optimal processing conditions in the wax injection molding process were investigated using Taguchi method. The experimental results revealed that the most influential factor affecting the weight of spilled wax during wax injection molding process is the injection time. The optimal processing conditions in the wax injection molding process are injection temperature of 82 ℃, injection time of 2 sec, injection pressure of 0.6 kgf/cm2 and mold temperature of 60℃. |
本系統之摘要資訊系依該期刊論文摘要之資訊為主。