查詢結果分析
來源資料
相關文獻
- 二氧化碳在鎳觸媒上甲烷化反應之研究
- Carbon Dioxide Methanation over Yttria-doped Ceria/γ-alumina Supported Nickel Catalyst
- 一氧化碳在鎳觸媒上甲烷化反應之研究
- 早期聲門癌以內視鏡二氧化碳雷射顯微手術治療的長期追蹤結果
- The Influence of Dust on Physiological Responses of Sweet Potato (Ipomoea Batatas) Leaves
- 二氧化碳顯影電腦斷層與二氧化碳顯影超音波於肝臟腫瘤之比較
- 抑制二氧化碳排放之可行對策
- 二氧化碳雷射燻煙的初步調查報告及安全防護
- 臺灣產業大地震--綠色風暴烏雲壓境
- The Dose Effect of Propofol on Cerebrovascular Reactivity to Carbon Dioxide in Rabbits
頁籤選單縮合
題名 | 二氧化碳在鎳觸媒上甲烷化反應之研究=A Study of CO[feaf]Methanation over Ni Catalyst |
---|---|
作者 | 吳仁彰; Wu, Ren-jang; |
期刊 | 觸媒與製程 |
出版日期 | 19990800 |
卷期 | 7:2 1999.08[民88.08] |
頁次 | 頁47-51 |
分類號 | 468.8 |
語文 | chi |
關鍵詞 | 二氧化碳; 鎳觸媒; 甲烷化反應; |
中文摘要 | 二氧化碳(CO□)是一種溫室氣體,目前世界各國正設法消減排放二氧化碳的濃度, 利用甲烷化(Methanation)反應來減量二氧化碳的濃度,也是一種方法。在另一方面,當二氧 化碳濃度介於ppb到100ppm的範圍時,一般都使用氣相層析儀火燄離子化偵測器(GC/FID) 來偵測。由於CO本身對FID的感度很低,因此需先經過觸媒氫化成甲烷後(此反應稱為甲烷 化反應,其反應式為CO□+4H□=>CH□+2H□O),FID再對甲烷偵測產生信號。商業上一般多 使用鎳混合金屬觸媒(Ni-Metal Mixing Catalyst)為甲烷化反應的催化劑,但是並無氫氣濃 度過量之條件下的觸媒活性資料。本研究以鎳粉觸媒為研究對象,通入過量氫氣,以GC/TCD 為偵測器,改變不同的反應溫度(35-400℃),測試溫度對觸媒活性的影響。結果得到當溫度 為350-400℃時,CO□的轉化率(Conversion)與甲烷的產率(Yield)接近100%。此結果可提供 作為二氧化碳GC/FID甲烷化反應之參考。 |
英文摘要 | The CO□ Methanation reaction is always important since CO□ is greenhousegas. It is well known that supported group VIII B metals are good catalysts for this methanation reaction. In generally, to measure the low concentration of CO □ in abaout ppb to ppm level is using by GC/FID/Methanation method. There are often using Ni Catalyst in methanation reaction in commercially, and no data in the condition of excess concentration of Hydrogen. A study of catalytic activity for CO2 methanation is performed in our laboratory, and the procedures of experiments were variation of temperature. In this study, CO□ conversion and CH□ yield and both near 100% and the activity of Ni catalyst is quite stable when the reaction temperature is 400℃. These results can be some useful reference in methanation reaction in the instrument of GC/FID. |
本系統之摘要資訊系依該期刊論文摘要之資訊為主。