查詢結果分析
來源資料
相關文獻
- Study of Elutriation from a Vortexing Fluidized Bed
- The Transport Disengaging Height in the Vortexing Fluidized Bed
- Characteristics of a Pilot Scall Vortexing Fluidized Bed Combustor
- 壓力式流體化床複循環(PFBC)發電技術
- Simulation of a Continuous Fluidized Bed Crystallizer--Perfect Classified Crystallizer Model
- 厭氧流體化床之生物膜顆粒層次模型及代謝活性試驗
- 各型煤炭燃料電廠移除二氧化碳之探討
- The Optimal Hydrodynamic Design of a Three-Phase Draft-Tube Fluidized Bed with an Orthogonal Array
- Treatment of High-Strength Nitrate Wastewater in Different Biological Denitrification Systems
- 影像處理應用於二維流體化床氣泡行為之研究
頁籤選單縮合
題名 | Study of Elutriation from a Vortexing Fluidized Bed=渦旋式流體化床中的淘淅研究 |
---|---|
作者 | 錢建嵩; 李仲明; | 書刊名 | 中原學報 |
卷期 | 33:1 民94.03 |
頁次 | 頁21-27 |
分類號 | 460.02 |
關鍵詞 | 流體化床; 渦旋式; 淘淅速率; Fluidized bed; Vortexing; Elutriation rate; |
語文 | 英文(English) |
中文摘要 | 本研究係於一內徑19公分高四公尺的壓克力冷模中進行,分別對傳統氣泡式流體化床(BFB)及渦旋式流體化床 (VFB) 做批式操作測試,空床氣速約0.9至1.8米/秒,床質為屬於B群粒子的玻璃珠,大粒子的粒徑為545微米,小粒子的粒徑為115微米。本研究提出一關聯關係式用以預估渦旋式流體化床中的比淘淅速率常數,實驗數據與預估值相當吻合。依據實驗數據我們發現中間同心圓出口可有較低的淘淅速率,缺點是乾舷區的壓降較大。 |
英文摘要 | A systematic investigation on the elutriation conducted in a cold model 0.19m diameter and 4.0m height was reported. Both bubbling fluidized bed (BFB) and vortexing fluidized bed (VFB) were studied by batch operation. The superficial velocity ranges from 0.9 m/s to 1.8 m/s. Glass beads classified in the B Group in Geldart's classification were used as the fluidized material. The diameter of the coarse particles was 545mm, and the diameter of fine particles used for the elutriation test was 115mm. An empirical correlation to predict the specific elutriation rate constant (K*) in VFB is founded in this study. The agreement between the calculated values and the experimental data is generally good. The results obtained from experimental data show that the concentric circle exhaust tube is the best design. The pressure drop within the freeboard at various superficial velocities is also reported. |
本系統之摘要資訊系依該期刊論文摘要之資訊為主。