查詢結果分析
相關文獻
- 由切屑幾何形狀探討理想車削加工條件
- 應用表面反應法於車削時和刀具限制接觸長度對切屑曲率半徑影響之研究
- Machining Parameters Selection for Stock Removal Turning in Process Plans Using a Float Encoding Genetic Algorithm
- 米種特性及加工條件對米乾膨發率之影響
- 利用雙軸擠壓技術製造素肉之研究(1)--加工條件對素肉品質之影響
- 高速、高效率--切削時代的切屑處理對策
- 非接觸式精密刀具定位系統之研製
- 切屑之寬厚度比對邊緣效應影響之探討
- 米乾製備、加工與其膨發率之相關性
- 加工處理對雞蛋蛋黃抗體安定性之影響
頁籤選單縮合
題名 | 由切屑幾何形狀探討理想車削加工條件=Investigation of Ideal Machining Conditions from the Study of Chip Geometry during Turning Operation |
---|---|
作者 | 游憲一; 楊孟瑤; | 書刊名 | 興大工程學刊 |
卷期 | 11:1 2000.03[民89.03] |
頁次 | 頁17-24 |
分類號 | 446.893 |
關鍵詞 | 車削; 切屑; 加工條件; Turning; Chip; Machining conditions; |
語文 | 中文(Chinese) |
中文摘要 | 本文就碳鋼車削過程中,量測加工中之切削力以及加工後的工件表面粗糙度,同 時在收集與分類加工後的切屑之後,分析其與切削力及表面粗糙度之間的形成相關性,以 期得到理想的加工條件。車削過程的切削變化條件為(一)切削速度,(二)進給率,及 (三)進刀深度。由實驗觀察可發現在較低的切削速度與較小的進刀深度下,切屑呈破裂 不連續狀態。但在一般切削條件下,以較大的切削速度加工時,所得到的切屑呈連續狀態。 自實驗結果顯示,在較高的切削速度下,配合適當大小的進給率及進刀深度,可得到較低 的切削力與較佳的加工表面精度。 |
英文摘要 | In the operation of turning machining on the carbon steel, the cutting forces during machining and the surface roughness of the machined parts are measured in this investigated. The chips for every turning operation are collected and classified. Its formation in relation to the cutting forces and surface roughness is analyzed. The primary physical parameters governing the turning process are (1)cutting speed, (2)feed rate and (3) cutting depth. The experimental results show that a broken or discontinuous chip is obtained under lower cutting speed and smaller cutting depth. The continuous chips are obtained when the cutting speed increases. In order to lower the cutting force and to obtain a better surface roughness, it is suggested that a higher cutting speed associated with proper feed rate and cutting depth is used during the turning operation. |
本系統之摘要資訊系依該期刊論文摘要之資訊為主。